Probably my biggest question is whether it will do more than the. posted by Hypertherm, it is just the machine I am looking for, but I have not found anything to back that up. I have scoured the internet for information, and found lots of good things, but very little with the machine being used on a CNC table. I do thank every one for their advice, and this post was just a desperate attempt at finding someone who knew where I could get some more detailed technical specs than in my manual since the dealer, and Google have not turned up anything useful.Īs for the PowerMax. I have tested almost every component on the board while sitting on my rear watching TV so I am fairly certain if I replace these few components there will not be a repeat of the burnt outs. ![]() The board went up in smoke due to a foreign piece of steel that wound up in the unit from a bonehead move I am too embarrased to admit. One the other hand three are complete toast, and there is no physical way to figure them out. Two resistors, and one diode are faulty, but not burnt to the point that I cannot identify them.
0 Comments
Leave a Reply. |